Assembling your 30mm Stone and Paver Wedge takes only a moment. This guide shows you how to align and lock the wedge with the spacer so the system performs correctly during your paving installation.

How It Works

The CLIP-IT Stone and Paver Wedge is designed to slide into the Stone and Paver Wedge Spacer. Once locked together, the two components create a stable, secure fit that helps maintain consistent paving levels.

Key Steps

1. Align the wedge with the spacer

Position the 30mm Stone and Paver Wedge so the front end lines up with the channel on the Stone and Paver Wedge Spacer.
Make sure both parts sit straight before pressing down.

2. Lock the wedge into the spacer

Press firmly on the rear of the wedge until it snaps securely into the spacer.
A clean click confirms that the wedge is fully locked in place.

3. Set and confirm

Check that the wedge is seated evenly inside the spacer.
Your assembly is now complete and ready for use in your paving project.

Pro Tip

Clear away any dirt or debris from the wedge and spacer before assembly. A clean connection ensures a proper snap and the most secure fit.

CLIP-IT is proudly Australian made and engineered on the Gold Coast.